MR 79 Remover (Box of 12 cans)

MR® 79 Remover
 Cleaner and Pre-Cleaner for penetrant testing
 according to EN ISO 3452-1:2013

General appearance and composition:
• Mixture of solvents based on a ketone, method C according to EN ISO 3452-2:2006
• Dries quickly
• Flash point material -19 °C
• Suitable for all metals (suitability for plastics needs testing prior to use)
• Testing security is guaranteed at work piece temperatures between -10 °C and +50 °C
• Aerosol overhead sprayable

Relevant approvals and specifications
• Sample testing acc. to EN ISO 3452-2:2006
• Low content of halogens and sulphur according to EN ISO 3452-2:20062 and ASME Code V, Section V, Article 6, T-641
• In correspondence with Lloyd's Reg., Bureau Veritas, Det Norske Veritas, admitted by Framatome ANP
• TLV 9017 01:2011-01

Application:
• Remove tinder, rust and other contaminations from surface in a suitable manner. You can use MR®79 Remover as precleaner for removal of oils or fats.
• Apply MR® Penetrant to the part to be tested either by spraying, brushing, flooding or dipping. Allow to penetrate for at least 5 minutes.
• Remove excess MR® Penetrant from surface using a clean lint-free cloth lightly moistened with MR® 79 Remover.
• Spray MR® Developer (e.g. MR® 70) from a distance of approx. 20 cm on the dry surface, achieving a thin, uniform layer. Depending on the used penetrant, surface defects will appear as red or fluorescent indications.
Please note: If the developer layer is too thick tiny discontinuities will not appear through the developer.

Minimum shelf life:
• Will keep for a minimum of 4 years, stored at room temperature

Pack sizes:
• Aerosols, 500 ml (1 box contains 12 aerosols)
• 5 L, 30 L, 200 L