12 cans of 500ml. MR® 88 Remover
for penetrant testing according to EN ISO 3452-1:2013
General appearance and composition:
Relevant approvals and specifications
Application:
Minimum shelf life:
Pack sizes:
for penetrant testing according to EN ISO 3452-1:2013
General appearance and composition:
- Mixture of solvents based on alcohol, method C according to EN ISO 3452-1:2013
- Dries slowly
- Flash point material +13 °C
- Suitable for all metals (suitability for plastics needs testing prior to use)
- Testing security is guaranteed at work piece temperatures between -10 °C and +50 °C
- Overhead sprayable
Relevant approvals and specifications
- Sample testing acc. to EN ISO 3452-2:2006
- Low content of halogens and sulphur according to EN ISO 3452-2:2006 and ASME Code V, Section V, Article 6, T-641
- In correspondence with Lloyd's Reg., Bureau Veritas, Det Norske Veritas, admitted by Framatome ANP
Application:
- Remove tinder, rust and other contaminations from surface in a suitable manner. You can use MR® 88 Remover as precleaner for removal of oils or fats.
- Apply MR® Penetrant to the part to be tested either by spraying, brushing, flooding or dipping. Allow to penetrate for at least 5 minutes.
- Remove excess MR® Penetrant from surface using a clean lint-free cloth lightly moistened with MR® 88 Remover.
- Spray MR® Developer (e.g. MR® 70) from a distance of approx. 20 cm on the dry surface, achieving a thin, uniform layer. Depending on the used penetrant, surface defects will appear as red or fluorescent indications.
Minimum shelf life:
- Will keep for a minimum of 4 years, stored at room temperature
Pack sizes:
- Aerosols, 500 ml (1 box contains 12 aerosols)
- 5 L, 30 L, 200 L
